Lay-Up Technician / Composite (Fiberglass) Laminator

RESPONSIBILITIES

Assemble detail components

Pre-fit the details to ensure conformity to customer

Lay-up assemblies in accordance with the mylars provided. May use cutting tools, heat guns and measuring equipment

Place mylar (blueprint) over the entire part to ensure correct placement

Visually inspect each piece. Call a Quality Inspector to inspect each detail

Complete all required information on the traveler form

Deliver parts to the table to be prepared for the

Work as part of a team to "bag" down the table. Process includes securing the parts with a bag and putting vacuum tubes in place using bag seal tape.

Inspection will verify the bag adequately passes leak check

Clean tables, floors, and hand tools on a daily basis

Lay-Up Technicians shall be certified after 90 days of hire

Other duties as assigned

EDUCATION AND EXPERIENCE:

High school diploma or general education degree (GED); or zero to three months related experience and/or training; or equivalent combination of education and

Composite (Fiberglass) lamination experience or b

oat, aviation, automotive, seamstress exp.

Ability to use cutting tools and measuring devices

ERP/Invoice software exp.

Ability to read blueprints, mylars, customer-supplied data

Airframe certification preferred but not required

Communication Skills:Must speak, read and write English. Ability to read and interpret documents such as safety rules, operating and maintenance instructions, and procedure manuals. Ability to write routine reports and correspondence. Ability to speak effectively before groups of customers or employees.Mathematical Skills:Ability to add, subtract, multiply, and divide in all units of measure, using whole numbers, common fractions, and decimals. Ability to compute rate, ratio, and percent and to draw and interpret bar graphs.Computer Skills:

Basic computer skills are required

```{=html}```

- Logging in / out of jobs using MRPMaterials and Equipment Used:

Scissors

Heat Gun

Tin Snips

Tape Measure (For reference only)

Scale

Calipers

Utility Knife/razor knife

Battery operated drill

Wrenches | Sockets | Clamps | Hammer/Malets | Tap and Die Sets | Scrapers

Chemicals Used:

MEK

Acetone

Mold Sealants | Mold Release

Isopropyl Alcohol

Adhesives

Personal Protective Equipment:

White Tyvek coats

W

hite cotton gloves

S

afety glasses (outside of lay-up room)

H

air/Beard net | Latex/Nitrile gloves

WORK ENVIRONMENTThe work environment characteristics described here are representative of those an employee encounters while performing the essential functions of this job. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions.While performing the duties of this job, the noise level in the work environmentisusually moderate but can be loud at times